[mothha]

What were the brush settings you used for the lines? I can't get mine to match this time.

pencil tool at 2 pt with opacity at 100% should work! keep pen pressure off as well and use the eraser to clean up lines ^__^

[Falaffle]

mark!!

[Caeleesi]

mark for home ehehe

[Bitesiz3d]

can we use the V2 lines

[appiesauce]

can we use the V2 lines

in this instance, i would say no, but you can always transfer the design onto the v2 lines after creating your myo!

[amaoretto]

marking,,,

[HexagonMustelid]

I can't get the lines right, they are always blurry. . .

[mothha]

I can't get the lines right, they are always blurry. . .

make sure you’re using the pencil tool (to the left of the pen tool) at 2 pt with opacity at 100%, and the setting “round pixelated” ! it should look like this

[HexagonMustelid]

make sure you’re using the pencil tool (to the left of the pen tool) at 2 pt with opacity at 100%, and the setting “round pixelated” ! it should look like this

Thanks, turned out a was just using the wrong setting. [I was using the square settings and not round pixelated.]

[PrincessAlexis]

Is this still open today or did I miss the deadline?