[MistCat]

Bump

[♎ Alinucard ♎]

Marking

[<sandfeather>]

Hello! So I am trying to make adoptable lines! Do I have to redraw the adoptable creature over and over again? Or is there a way I can shrink it and multiply it? I have read the entire post a couple times now, and I can't find anything to help me do that! Any help would be really appreciated!

[MistCat]

Hello! So I am trying to make adoptable lines! Do I have to redraw the adoptable creature over and over again? Or is there a way I can shrink it and multiply it? I have read the entire post a couple times now, and I can't find anything to help me do that! Any help would be really appreciated!

You can copy and shrink it, im terrible with explaining things, however, there is a "how to use Oekaki" thread you can look at. (I'd give you link, however, im on mobile phone, so its super hard to do so.)

[<sandfeather>]

Thank you so much for responding! I read the 'How to use Oekaki thread' a couple of times and still can't find it! Although there's a good chance I may of skipped over it!

[MistCat]

Thank you so much for responding! I read the 'How to use Oekaki thread' a couple of times and still can't find it! Although there's a good chance I may of skipped over it!

Your welcome! Hmm, try going to Oekaki, make a new layer and scribble a quick drawing. Then, click "edit" at the top, then when the tool bar comes up click "Transform" tool. Select around your drawing-make sure your on the same layer as what you want to select- then go click edit again. Click "copy". Click edit again then click "paste". It should work... If not, try using "select" tool rather then "transform" tool... sorry if that just sounds too confusing... Hope it helps

[<sandfeather>]

It really does help!!! Thank you so, so much!!!

[MistCat]

up

[badass skeleton]

Up

[tsukasa.]

mark!